2011年7月27日 星期三

Symantec Altiris Multiple NICs 多張網路卡

原文 http://www.symantec.com/business/support/index?page=content&id=HOWTO2774

Error Message: (開機 BIOS 畫面)
TFTP open timeout.

原因:
Altiris 6.9安裝在多張網路卡的server,TFTP只會起在其中一張網路卡,改設定可讓TFTP起在多張網卡上。

解法:

  1. From the PXE Configuration utilty File pull-down menu, click on Choose PXE Serverand specify your PXE server (not "Shared Configuration"). Close PXE Configuration.
  2. Make some change to the local PXE server configuration and then change it back, such as change the default timeout from 3 seconds to 4 and then back to 3 seconds. Then clickSave and then OK.
  3. Stop the PXE Manager and PXE Config Helper services.
  4. Navigate to the PXE folder and open PXEManager.ini with a text editor. Find the entry similar to “[PXEServer\3164593f-f64b-4d8e-92d1-a58a4890e47a\ListeningNICs]”. At this point there should be only one of these entries. This will be the last entry in the PXEManager.ini.
                Change the INI entry to:
                [PXEServer\3164593f-f64b-4d8e-92d1-a58a4890e47a\ListeningNICs]
                NICs="192.168.0.1","10.0.0.1","172.0.0.1"
                HasCustom=True
                Note: The GUID entry will be different for each PXE server. The PXE  Server GUID is located in the PXE.ini file at the PXE Server install location.

    NICs are variables that contain the IP addresses you want PXE server to listen. Change the IP addresses to fit your environment.

    Save the changes and close the text editor.
  5. Restart the PXE Manager and PXE Config Helper services.
  6. Send a simple job to a single client in all subnets. PXE will be listening in all IP addresses set in the above step. 
  7. You might want to verify that the PXE Server service is listening on all IP addresses specificed by using either a "netstat -an" command or by using a utility such as TCPView.exe from Microsoft.com.

沒有留言:

張貼留言